CSF myelin basic protein

• A
• B
• C
• D
• E
• F
• G
• H
• I
• J
• K
• L
• M
• N
• O
• P
• Q
• R
• S
• T
• U
• V
• W
• X

This is a test to measure the level of myelin basic protein in the cerebral spinal fluid (CSF). Myelin is a substance that covers the nerves and acts as an insulator. Without this insulation, information from nerves would be transmitted inefficiently which might result in weakness, sensory loss or other neurologic dysfunction.

Myelin basic protein (MBP) refers to one of the components found in myelin and is a marker of its presence. MBP is measured in the spinal fluid as to determine if there has been inflammation and myelin breakdown in the central nervous system.

A lumbar puncture (spinal tap) is the most common means of collecting a specimen of CSF. You are positioned on your side with your knees pulled up to your abdomen and your chin tucked in to your chest. Occasionally, this procedure is performed with the person sitting bent forward.

The skin is scrubbed, and a local anesthetic is injected over the lower spine. The spinal needle is inserted, usually between the 3rd and 4th lumbar vertebrae. Once the needle is properly positioned, the fluid pressures can be measured and fluid can be collected.

After the sample is collected, the needle is removed, the area is cleaned, and a bandage is applied. You will be asked to remain flat for 20 minutes to 1 hour after the test. The sample of at least 3 cc is taken immediately to the laboratory for evaluation.

Be prepared to sign a consent form and to remain in the hospital for at least several hours for observation.

The curled position may be uncomfortable, but you must remain still to avoid moving the needle and possibly injuring the spinal cord.

The scrub will feel cold and wet. The anesthetic will sting or burn when first injected. There will be a hard pressure sensation when the needle is inserted, and there is usually some brief pain when the needle goes through the covering of the spinal cord. This pain should stop in a few seconds.

Overall, discomfort is minimal to moderate. The entire procedure usually takes about 30 minutes, but it may take longer. The actual pressure measurements and fluid collection only take a few minutes.

This test is performed to determine if your nervous system shows active myelin breakdown. Multiple sclerosis is the most common cause for myelin breakdown (demyelination), but other causes may include:

• Encephalopathies
• Stroke
• Central nervous system hemorrhage
• Central nervous system trauma

Review Date: 04/28/2005
Reviewed By: Chitra R. Uppaluri, M.D., Clinical Assistant Professor of Medicine, Saint Louis University, St. Louis, MO. Review provided by VeriMed Healthcare Network.